Helical Gears
October 2, 2026

Spur Gears for Drill Rig

Drill-rig drives often need a straightforward, efficient gear mesh that can be produced to a drawing and replaced in the field from a worn sample. Spur gears — straight teeth on parallel shafts — are a common choice in that kind of power path. Foshan Nanhai Lianyi Gear Factory manufactures them to your specification.

This page does not list separate drill-rig-only ratings. Capacity, materials, and precision are the same factory-wide figures already published for our spur gears.

Typical use in this application

On a drill rig, spur gears are typically used where shafts run in parallel and the drive needs a simple, efficient mesh — for example in a gearbox or auxiliary drive that takes power from the prime mover and delivers it to the working equipment. Because the teeth are straight, the geometry is well understood, and a replacement can be cut from a drawing or from a worn sample when the original paperwork is missing.


Key Features
  • Straight teeth for an efficient mesh on parallel shafts
  • Produced to your drawing, or reverse-engineered from a worn sample
  • Heat treatment, grinding, and finishing available
  • Factory-wide capacity as already published for our spur gears (see specifications below)
Technical Specifications
  • Diameter range: up to 3.2 meters
  • Module range: 1–40 mm
  • Materials: alloy steel, carbon steel, stainless steel, and more
  • Precision levels: up to Grade 5
  • Surface treatment: heat treatment, grinding, and finishing